DACS FwS FREQue II Technical Specifications:

Freq Response: Flat from <10Hz to a -3dB point at around 65kHz

Signal to Noise Ratio: -82dB (equivalent to a good microphone set to medium gain)

Input Connectors: 1/4" jack, three pole, TRS balanced

Output Connectors: 1/4" jack, three pole, TRS balanced

Additional Inputs: CV Inputs to each oscillator on two pole 1/4" jacks, 0-15V, V/Hz

Additional Outputs: Output for both oscillators on two pole 1/4" jacks

Meters: on MOD and Music I/P Green LED illuminates increasingly brightly from -40dB, orange LED illuminates increasingly brightly from +2dB

Oscillator: Selects from four ranges in which COARSE and FINE vary the range - also has direct out and CV in to modulate FREQuencies even further

Fine: Varies around centre frequency by ca 5%

Coarse: Varies centre frequency over selected range

Range: Selects from frequency range of around 0.04 Hz to 28.5 Hz, 5 Hz to 153 Hz, 30 Hz to 1.3 kHz, and 111 Hz to 16.5 kHz

OSC2 to RM1: Connects oscillator 2 to ring modulator 1 (disconnected when FREQue activated)

FM Switch: Uses OSC1 to Frequency Modulate OSC2 - can work in conjunction with external CV input and FREQue

FM Depth: Varies depth of Frequency Modulation

FREQue: Activates Frequency Shifter, OUTs 1 and 2 become frequency shifted versions (UP and DOWN respectively) of the combined MUSIC inputs shifted by the frequency of OSC2

Levels: Input level controls vary input gain from -6dB to +12dB. The output mixes between the MUS input and modulated output. For input levels of +4dBu to +12dBu output will be around +4dBu-+12dBu, maximum output level +20dBu